Skip to content
The Cyano Codex
Choose language

Cyanotype postcards and cards

A cyanotype postcard is a card of heavy paper with a white silhouette on Prussian blue on the front and a blank back for writing. It’s one of the most rewarding projects to start with: small format, little solution and a whole series in one sunny morning. Here’s how to make one.
Section
Projects
Reviewed
Reading time
8 min
Sources
9
Level
Beginner (level 1 of 3)

As an Amazon Associate I earn from qualifying purchases. How we fund the site

Six cyanotype postcards with fern, ginkgo, wheat ear, olive, umbel and eucalyptus, seen from above
Plate 1Six postcards, six plants.
Time
One session for a series, plus drying and flattening
Level
Beginner
Materials
9
Steps
5

In short

  • Cyanotype postcards were already being made in the late 19th century, on card stock thicker than paper.
  • An A6 format and a heavy cotton paper with no alkaline buffer make a sturdy postcard.
  • Make series: six plants, six postcards, all with the same margin and the same light.
  • The back stays white if you coat only one side: that’s where the message goes.
  • Keep them in the dark until you send them: strong light fades the blue.

Safety: Wear safety glasses and nitrile gloves to mix and brush on the solution; if it splashes into your eyes, rinse with plenty of water for 15 minutes. More on safety

Safety: When exposing in the sun, protect yourself as you would for any time outdoors: shade while you wait, UV-blocking sunglasses and sunscreen; don’t look at the sun. More on safety

Materials list

Check off what you already have on the table. The “Amazon” links are affiliate links.

To prepare
To coat
  • How to choose
  • How to choose
To expose
To develop
To finish

Your check marks are saved only in this browser. No account needed.

On this page (5 sections)
  1. What is a cyanotype postcard?
  2. Before you start
  3. Postcards, step by step
    1. 1. Choose the format and the paper
    2. 2. Prepare the images for the series
    3. 3. Expose the whole series at once
    4. 4. Wash and flatten
    5. 5. Write on the back
  4. Variations
  5. Caring for the postcards

What is a cyanotype postcard?#

A cyanotype postcard is a card of heavy paper with a Prussian blue image on the front and a blank back for writing. It isn’t a new idea: in the late 19th century cyanotype was used for postcards, with the chemistry applied to card stock thicker than paper1.

It’s one of the most rewarding projects to start with. The format is small, it uses little solution, one afternoon is enough for a whole series, and every card comes out different. With sun print paper, which is still sold for teaching and as an educational toy1, you don’t even need to mix chemistry.

Before you start#

This project assumes you know the basic technique, which is covered in how to make a cyanotype step by step. If you’d rather start without chemistry, choose small-format sun print paper: how to choose it is explained in sun print paper for cyanotype.

Decide beforehand whether you’re making a series or single postcards. A series, with the same size, the same margin and a different plant on each card, makes a much better gift than unrelated single cards.

Postcards, step by step#

Cyanotype postcards take five steps: choose the format and paper, prepare the images for the series, expose the whole batch at once, wash and flatten, and write on the back. One sunny morning is enough for a complete series if you have several boards.

  1. Prepare

    Step 1: Choose the format and the paper

    A6, 10.5 × 14.8 cm, is a convenient format: you get four from an A4 sheet. Use a heavy paper that won’t bend when you write on it: cotton watercolor paper with no alkaline buffer, the calcium carbonate additive that chemist Mike Ware advises against for cyanotype2. Ware gives 160 g/m² as a sufficient weight for sheets up to A42.

    If you coat the paper yourself, do it in large sheets, on one side only and with a white margin around each postcard, and cut them after washing. Use it soon: Ware advises using sensitized paper within a few hours or storing it cold, dark and dry2.

    Safety: Wear safety glasses and nitrile gloves to mix and brush on the solution; if it splashes into your eyes, rinse with plenty of water for 15 minutes. More on safety

    How to tell it’s going well: you have one card per postcard, plus the test strip and a few spares.

  2. Prepare

    Step 2: Prepare the images for the series

    Gather as many images as postcards: six different pressed plants, six pieces of lace, six drawings on transparency film. Anything opaque will print white, and anything that lets some light through will print a lighter blue. To give the series unity, place all the images at the same scale and in the same position on the card.

    If you want a postcard of a place from a photo, you need a negative the same size as the postcard, printed on transparency film.

    How to tell it’s going well: when you line them up on the table, the images are similar in size and distinct in shape.

  3. Expose

    Step 3: Expose the whole series at once

    First make a test strip on an offcut of the same paper, with times that double from one section to the next3. The time depends on the formula, the light and the paper, and in the sun on the time of day and the clouds4: that’s why it pays to expose the whole series in the same session.

    Assemble the cards in the shade, in soft light, out of direct sun5, each on its own board with its own glass, and take them out into the sun together.

    How to tell it’s going well: all the cards have changed color evenly around the images.

    Safety: When exposing in the sun, protect yourself as you would for any time outdoors: shade while you wait, UV-blocking sunglasses and sunscreen; don’t look at the sun. More on safety

  4. Develop

    Step 4: Wash and flatten

    Wash the postcards until the whites are clean, with no yellow tint6, and let them dry flat. The blue darkens on exposure to air over the following hours, in about 24 hours according to Ware and Jacquard2,7. If they’ve curled, leave them overnight between blotting paper with some weight on top.

    How to tell it’s going well: the postcards are flat, the blue has fully developed and the edges are straight.

    Safety: Keep leftover solution and the first wash bath in a closed, labeled container for your local hazardous waste collection point; later rinses can go down the drain with plenty of water. More on safety

  5. Finish

    Step 5: Write on the back

    If you coated only one side, the back is white paper: write with a pen or pencil once the postcard is completely dry. You can draw a pencil line to separate the message from the address, like on traditional postcards.

    To send it, an envelope is best: it protects the card from rubbing and from light on the way.

    How to tell it’s going well: the message is easy to read and the front hasn’t smudged while you wrote.

Variations#

Postcards take almost any image that fits in your hand. These variations change the subject, the format or the occasion, and keep the same batch and flattening process.

Travel postcard. Press a few leaves from the place you visit and make the postcard when you get home: the silhouette of a plant from that landscape is a reminder of the trip.

On printed paper. Cyanotype is transparent, like a dye: Jacquard explains that on a printed background whatever is underneath shows through8. A page from an old map or from sheet music makes a postcard with a story.

Seasonal greetings. For Christmas, the ideas and the problem of winter light are covered in Christmas cyanotypes. For a wedding, the same technique works as a save-the-date, as we explain in cyanotype wedding invitations.

Folded card. A folded card with the cyanotype on the front and a blank inside for writing. Coat only the half that will be the front.

Caring for the postcards#

Postcards live on fridges, bulletin boards and shelves, often near a window. Mike Ware found that one hour of direct sun fades a cyanotype much more than the same amount of light received at lower intensity9: whoever receives it should hang it away from the sun.

If it fades, it can be fixed. In Ware’s tests, a cyanotype faded by light recovered at least 95% of its density in a day in the dark9. More gift ideas in cyanotype ideas, and more projects with cards and paper in published guides like this one, in English.

Frequently asked questions

What size is a cyanotype postcard?

Whatever size you like, but A6, 10.5 × 14.8 cm, is a good starting point: it’s easy to handle, uses little solution and fits in a standard envelope. You get four from an A4 sheet. If you use sun print paper, check the sizes each pack comes in.

What paper should I use for cyanotype postcards?

A heavy one that won’t bend when you write on it or curl when you wash it: cotton watercolor paper, with no alkaline buffer so the blue lasts. Mike Ware gives 160 g/m² as a sufficient weight for sheets up to A4. In the 19th century, postcards were made on card stock thicker than ordinary paper.

Can you write on the back of a cyanotype postcard?

Yes. If you coat only one side, the back stays like white paper and takes pen or pencil. Write once the postcard is completely dry and flat. Avoid getting the back wet or using stickers that show through, and keep the postcard in the dark until you send it.

Can you mail cyanotype postcards?

Yes, preferably in an envelope: it protects the card from rubbing and from light on the way. Strong light fades the blue, although it recovers almost completely in the dark. If you send it without an envelope, expect the front to arrive with some wear.

Your next step

Make your Christmas cards in cyanotypeHow to make cyanotype Christmas ornaments, cards and gift tags: branches, lace and stars, how to expose in winter light and how to store them.

Sources

  1. Stulik, D. C. and Kaplan, A. (2013). Cyanotype. In The atlas of analytical signatures of photographic processes. Getty Conservation Institute. https://www.getty.edu/conservation/publications_resources/pdf_publications/pdf/atlas_cyanotype.pdf 12
  2. Ware, M. (2009). New Cyanotype: Siderotype workshop notes. https://www.mikeware.co.uk/downloads/CyanoWork.pdf Accessed October 17, 2026. 1234
  3. Ilford Photo. (2017, March 30). Making a black & white print: Exposure testing. https://www.ilfordphoto.com/exposure-testing/ Accessed October 16, 2026.
  4. Ware, M. (n.d.). The New Cyanotype process. Mike Ware: Alternative photography. https://www.mikeware.co.uk/mikeware/New_Cyanotype_Process.html Accessed October 16, 2026.
  5. Redden, H. and Crawford, A. (2025). Anna Atkins and the making of macroalgae cyanotypes and their role in science education. Applied Phycology, 6(1), 1-8. https://doi.org/10.1080/26388081.2024.2435049
  6. Ware, M. (n.d.). The traditional cyanotype process. Mike Ware: Alternative photography. https://mikeware.co.uk/mikeware/Traditional_Cyanotype.html Accessed October 16, 2026.
  7. Jacquard Products. (2021). Cyanotype detailed instructions [Manufacturer instructions, version 08.17.21]. https://cdn.shopify.com/s/files/1/0053/5540/5423/files/Cyanotype_Instructions.pdf Accessed October 16, 2026.
  8. Jacquard Products. (2019). Cyanotype FAQs [Manufacturer’s document, version 02.08.19]. https://cdn.shopify.com/s/files/1/2714/2506/files/Cyanotype-FAQs.pdf Accessed October 17, 2026.
  9. Ware, M. (2003). A blueprint for conserving cyanotypes. Topics in Photographic Preservation, 10, 2-18. https://resources.culturalheritage.org/pmgtopics/2003-volume-ten/10_02_Ware.pdf 12

Reviewed on October 16, 2026. If you spot an error or a missing source, write to us and we’ll look into it.